Finished furnace installation with clean transitions and utility connections

Southwest Riverside County & the Temecula Valley

Furnace & Heating Installation — Temecula Valley

The furnace-or-heat-pump call, made with your bills on the table.

A heat pump can heat and cool your home on one efficient system. We handle sizing and install, with the permit process and HERS handled per request — and if incentives or financing are part of the picture, we walk you through the options at the estimate.

American Standard Customer Care DealerLicensed, bonded & insured · CSLB #349958BBB A+ Accredited BusinessNATE-certified ownerTop 3% of California contractors (BuildZoom)

Ask about financing at your estimate

Real numbers for your actual system — not a teaser rate on a banner.

How financing works

The fuel decision

Furnace or heat pump — sized here, priced straight, no vapor rebates.

Panel capacity, duct condition, and gas service decide which options your house can even take — that's where the estimate starts.

  1. Old furnace out

    Removed and hauled away the same day.

  2. Transitions & venting

    New sheet metal and flue, sized and sealed to the new furnace.

  3. Fire-up & verify

    Heat proven at the registers before the truck leaves.

Home load

Rooms, glass, insulation

Duct readiness

Reuse, seal, or resize

Panel / gas

Electrical and fuel path

Incentives

Checked at quote time

The estimate, itemized

  • Heat pump conversions and furnace replacements sized to your home

  • Dual-fuel hybrid options at your $75 in-home estimate — credited toward the equipment

  • Title 24 compliance handled; independent HERS verification coordinated per request

  • Existing furnace or condenser removed and hauled on install day

  • Manufacturer coverage up to 12 years on qualifying American Standard systems

One changeout

The same closet, before and after

The furnace half of a full system replacement. The original unit out, a new American Standard in its place, with new venting and line work.

The old beige furnace in a garage closet with original ducting above it

Before

The furnace that came out
The new American Standard furnace in the same closet with new flue and line work

After

The new furnace in the same closet

Both photographs show the furnace on the same job, the same day.

Estimate path

How a heating install goes

  1. 1

    In-home estimate

    Load calculation plus a straight talk about whether a heat pump, furnace, or hybrid fits your house and your bills.

  2. 2

    Incentive check

    Program status checked the week we quote, and we file whatever paperwork applies.

  3. 3

    Install, permit, HERS

    One to two days. Permit process and independent duct testing handled per request, inspection-ready.

Heating Installation & Heat Pumps services

Pick the exact job — each one has its own page.

Heating install questions

Still have a question?

Call (951) 672-0397
Will a heat pump keep up on 40° valley mornings?

Yes. Modern inverter heat pumps hold full capacity well below anything the Temecula Valley sees. The old cold-climate objection doesn't apply here.

Should I wait for a rebate before replacing?

Not if the system is failing — a mid-July breakdown costs more than any likely rebate, and program funding moves without much notice. If yours still runs fine, waiting is a real option and we'll say so at the estimate.

Are there rebates available for a heat pump right now?

It depends on when you ask — utility and state programs open and close as funding moves. We check what's actually fundable at quote time rather than promising a program that may be out of money.

(951) 672-0397Get Estimate